Objecteering CM Synergy parameters

The Objecteering CM Synergy MDAC provides two additional MDAC parameters in the "CM Synergy" parameter set.

The ... parameter	is used to ...
Default task	visualize the default task from Objecteering. This information is not used by the MDAC. To select the default task, the "Select default task" command must be run.
Start the session in GUI mode	remember whether the CM Synergy session has been started in GUI or in command line mode. This parameter must not be modified directly. You should first run the "Stop session" command of the CM Synergy administration MDAC followed by the "Start session". Then you can check or uncheck the tickbox.